Need help?Do you have a question about the inVue CT100 and is the answer not in the manual?
General| Type | Tablet Stand |
|---|---|
| Function | Security and display |
| Color | Black |
| Compatibility | Tablets and other mobile devices |
| Material | Aluminum |
Lists all parts of the system, including tablet stand, shroud, power connector, power supply, and IR key.
Explains the purpose of the tablet stand and shroud for securing a tablet.
Drill a 19 mm hole and clean the surface with an alcohol wipe.
Plug the power connector into the merchandise.
Slide tablet into shroud, attach shroud to merchandise, and tighten screws.
Remove battery tab, films, and secure the stand post through the hole.
Attach washers to the stand below the counter and loosely tighten.
Snap the shroud onto the stand and confirm it is fully engaged.
Ensure the shroud is aligned with the counter and fully tighten the washer.
Plug the power supply into the OEM device and then into the outlet.
Rotate the shroud 90 degrees to display the tablet in landscape orientation.
Use the IR key on the IR lens to release the shroud; it will auto-relock.
Remove screws with TT15 bit, lift handle, and slide shroud off to remove merchandise.
Provides answers to common issues like power, lock engagement, and stand stability.
To Next Page