Decide how the power cable will
be routed. There are 4 options; the
power cable can be routed out from
the back of the base (Option A), out
either side of the base (Options B or
C) or the power cable can be routed
straight down through the xture
(Option D shown in the next step).
2a
OneKEY
Counter Detacher
AKD40
Screw Mount (Optional):
Peel the clear lm from the 3
adhesives on the bottom of the base.
3a
1
Use the provided alcohol wipe to
clean the area where the Detacher
will be placed, either on a horizontal
or vertical surface. Allow it to dry
completely.
1
CONTENTS: One pad saturated in 75%
Isopropyl Alcohol
DIRECTIONS: Apply topically as
needed to cleanse surface mounting area.
FOR EXTERNAL USE ONLY
KEEP OUT OF REACH OF
CHILDREN
KEEP AWAY FROM EYES
AND FIRE
CONTENTS: One pad saturated in 75%
Isopropyl Alcohol
DIRECTIONS: Apply topically as
needed to cleanse surface mounting area.
FOR EXTERNAL USE ONLY
KEEP OUT OF REACH OF
CHILDREN
KEEP AWAY FROM EYES
AND FIRE
If mounting the base over a hole, the
power cable can be routed straight
down through the xture.
2b
Place the base in the desired location
and use the 2 provided screws to
secure the base to the xture.
3b
Or
Option A
Option B
Option C
Option D
3c
Insert one side of the pad into the
rim of the base. The tabs on the pad
will t into the slots on the inner rim
of the base.
3d
Apply pressure around the edge of
the pad to fully secure the pad in the
rim of the base.
To Next Page
Need help?
General
