Place the base in the desired location
(either on a horizontal or vertical surface)
and apply pressure for at least 10
seconds.
4b
6
Plug the power supply into a power
outlet. The LED on the key will be
red.
7
To activate the Detacher, hold a charged
and coded OneKEY close to the nose of
the Detacher key. Press the button on
the OneKEY. The LED on the Detacher
key will turn blue when successfully
coded.
5
Plug the Detacher’s power cable into
the PS18V power supply.
8
Place the Detacher key onto the
base.
4a
Adhesive Mount: Peel the clear
lm from the 3 adhesives on the
bottom of the base
4c
Insert one side of the pad into the
rim of the base. The tabs on the pad
will t into the slots on the inner rim
of the base.
4d
Apply pressure around the edge of
the pad to fully secure the pad in the
rim of the base.
To Next Page
Loading...
