inVue OneKEY - User Manual

OneKEY
IR4 Keys, Chargers & OneKEY Manager
Section 1: Charger (4 & 8
Position) Installation
• Adhesive Mount - Use the
povided alcohol wipe to clean the
area where the charger will be
placed. Allow it to dry completely.
1a
CONTENTS: One pad saturated in 75%
Isopropyl Alcohol
DIRECTIONS: Apply topically as
needed to cleanse surface mounting area.
FOR EXTERNAL USE ONLY
KEEP OUT OF REACH OF
CHILDREN
KEEP AWAY FROM EYES
AND FIRE
Determine how the cable will be
routed. There are 3 exits on the bot-
tom of each charger.
1b
Peel the clear lm from the adhesives
on the bottom of the charger (4
adhesives on the 4 position charger
and 6 on the 8 position charger).
1c
Route the cable as determined in
Step 1b, place the charger where
desired and apply pressure for at
least 10 seconds.
1d
1
2
3
The cable can also descend down
through the xture if a hole or slot is
present.
1c
2b
Place the charger onto the screws.
Screw Mount - Drill 2 small pilot
holes based on the distances (either
horizontally or vertically) below that
correspond to your charger.
• 4 Position Charger - 60mm (2
3
/
8
in).
• 8 Position Charger - 130mm (5
1
/
8
in).
Insert the screws (not provided,
choose screws appropriate to the
xture’s material) into the pilot holes.
Allow enough of the screw sticking
out to hang the charger.
2a
60mm (2
3
/
8
in)
130mm (5
1
/
8
in)

Summary

Charger Installation

Adhesive Mount Installation

Clean the mounting area with an alcohol wipe and allow it to dry completely.

Cable Routing and Mounting

Route the cable through bottom exits or fixture slots and mount the charger using adhesive or screws.

OneKEY Charging and Manager Setup

Charging the OneKEY

Connect the Key to the charger and allow it to charge for 6 hours before use.

OneKEY Manager Power Connection

Connect the OneKEY Manager to its power supply and then to a power outlet.

OneKEY Manager Enrollment

Network Connection and Configuration

Connect the Manager to the network, select language, and configure network settings.

Entering Installer Code

Input the OKM Installer Code for automatic system configuration.

Access Manager Integration and Site Creation

Identifying and Linking the OKM

Locate the OKM's MAC address and match it to the entry in Access Manager for linking.

Creating a New Site Code

Decide whether to create a new site code automatically or transfer from an existing key.

Site Code Transfer (IR4)

Transferring IR4 Site Codes

Sync a new IR4 OneKEY with your existing system by placing it onto the OKM.

Site Code Transfer (Legacy)

Transferring Legacy Site Codes (IR2;IR3)

Follow specific procedures for IR2 and IR3 keys to transfer store codes to the OKM.

Checking Out a OneKEY

Performing the Check Out Process

Remove a charged Key, place it on the OKM, and enter PIN if using Access Manager to check out.

Checking In a OneKEY and Precautions

Performing the Check In Process

Place the Key onto the OKM to sync and then return it to the charger for the next user.

Care and Battery Warnings

Guidelines for cleaning the touchscreen and important warnings about device batteries.

Regulatory Compliance

FCC and ISED Compliance Statements

Read compliance information regarding radio frequency emissions and interference.

inVue OneKEY Specifications

General

Brand	inVue
Model	OneKEY
Category	Locks
Language	English