IOGear GCS1102 - Page 26

26
Step 9
If you have checked the “Check Firmware Version”
checkbox, then the utility will check the current
rmwarethatisonyourKVM.Ifthecurrentrmware
isnewerthanthermwarethatyouwishtoupgrade
to, a window will popup and prompt you to ask if
you wish to proceed. Simply click “Yes” to start the
upgrade and “No” to cancel the upgrade.
Note: If you did not check the “Check Firmware
Version” checkbox, utility will perform the upgrade
automaticallynomatterwhatversionofrmware
you have in the KVM.
Step 10
Whenthermwareupgradeisdone,youwillsee
“Firmware upgrade OK” in the “Status Messages”
window. Then simply click “Finish” to complete the
wholermwareupgradeprocess.