14140 NE 200th St. Woodinville, WA. 98072 PH: (425) 398-8282 FX: (425) 398-8383
FlexJet Logic Board replacement
Tools Required:
Phillips head screwdriver
5/32” Allen wrench.
2. Remove the right side cover of the machine
(There are a total of 5 screws. 2 black phillips screws on the end
plate, One silver phillips screw on the back, and two silver phil-
lips screws on the bottom.)
3. Remove 6 of 8 screws that hold the printer to the
stand on both sides. See drawing below for the right
screws to remove.
CAUTION: The printer is VERY heavy. Always stand
behind the machine while performing this task.
1. Unplug the take-up motor cable from the bottom of
the machine. Unplug the power and serial cable.
4. Stand behind the machine and lift it by the rear bar
holding your hands 6” from the end plates. Roll the
machine forward on the stand until it comes to rest in
the forward position.
Remove these screws
ONLY
DO NOT REMOVE!
Take-up motor cable
P/N: 108497 R2
To Next Page
Need help?
General