Need help?Do you have a question about the Ioline FlexJet E and is the answer not in the manual?
Explains critical settings like COM port and baud rate for communication between PC and printer.
Overview of the Control Center utility for adjusting settings and sending files to the printer.
Explanation of why and how to calibrate the printer to ensure accurate output matching design intent.
Steps to print a calibration box and measure its dimensions using the Control Center software.
Procedure for entering measured calibration values into the Control Center and applying them to the printer.
Instructions for adjusting carriage scan alignment using the Control Center to fix scan alignment issues.
Instructions for adjusting paper scan alignment using the Control Center to fix gaps between scans.
Key practices for maintaining print quality, including checking cartridges and performing cleaning procedures.
Procedure for preparing the printer, checking version, and updating firmware via the Control Center software.
Steps to reset calibration values to factory defaults or re-enter them after alterations.
Initial steps to diagnose problems by checking the computer, cable, software, and printer connection.
Resolving issues with paper slipping or misalignment that degrade printing quality.
Factors affecting print quality and troubleshooting steps for common problems like misaligned scans.
Troubleshooting steps for uneven line quality, including cleaning cartridges and checking paper.
Diagnosing and resolving issues related to serial port communication, baud rate, and connectivity.
Interpreting keypad error codes and LED light patterns to diagnose printer status and faults.
Addresses common problems like plots not starting correctly, not completing, or no output.
Troubleshooting jagged scan alignment, poor paper tracking, and gaps between scans.
To Next Page
General