Iomega Peerless - Separating the Peerless Base Station

It is not necessary to remove the Peerless disk from the base station when you shut down your computer as
long as it remains completely inserted. If the Peerless disk is ejected from the base station when you shut
down your computer, remove it and store it in its case.
Separating the Peerless Base Station
To separate the Peerless base from the interface module:
1. Eject the Peerless disk from the base station as explained above.
2. Then simultaneously squeeze the release buttons (shown below) on the Peerless base and slide it out
of the interface module.