Manual técnico
ATTENTION: Dispose of plastic bags properly and
keep them out of the reach of children, as they
may be dangerous to them.
Inside you will find: Water treatment equipment, insta-
llation accessories and documentation...
The materials used in the packaging are recyclable and
should be disposed of in the appropriate selective co-
llection containers or at the local centre specifically for
the recovery of waste materials.
This product should not be disposed of together with
normal urban waste. At the end of the useful life of the
equipment, it must be delivered to the company or
centre where the device was purchased, or to a speci-
fic local Clean Point or centre for the recovery of ma-
terials, indicating that it has electrical and electronic
components. The correct collection and treatment of
unserviceable equipment contributes to preserving na-
tural resources and also to avoiding potential risks to
public health.
5. INSTALL ATION
The installation of your osmosis equipment
must be carried out by a qualified staff.
Read this manual first and if you have any
questions, consult your dealer.
ATTENTION: Since the appliance to be installed
improves the quality of the water to be consumed,
all the tools to be used for assembly and installation
must be clean and under no circumstances must they
be contaminated or permeated with grease, oils or
oxides. Use tools exclusively for cutting tubes, handling
membranes, etc. Keep them clean and disinfect them
periodically.
ATTENTION: The work must be carried out with a
proper approach and hygienic conditions, taking
extreme precautions in everything related to ma-
terials and components that are going to be in contact
with the water to be treated or consumed.
(For more information contact your distributor).
ATTENTION: Prevent the risks of external conta-
mination of the equipment by handling it proper-
ly, by using gloves, hand sanitizing gel or washing
hands as often as necessary throughout the installa-
tion, start-up and maintenance of the equipment.
The most common place to install the equipment is
usually under the kitchen sink or in an adjacent cabinet.
Install the faucet, hydraulically and electrically, to the
drain collar and inlet adaptor and connect them to the
respective equipment connectors (5, 6, 6.1 and 7).
6
7
ATTENTION: Some of the accessories for the installa-
tion may vary depending on the model and the region
in which the equipment is distributed.
5.1. MIXING KIT
- If you wish to increase the pH, conductivity and chlorine
concentration at the outlet, you must install according to the
following diagram and using the corresponding components
included in the mixing kit (consult your distributor).
- After starting up, open the tap and with the corresponding
meter of the parameter of interest, measure in the water
dispensed by the tap and slowly and progressively open the
mixing valve until the desired parameter is achieved.
- The water dispensed must comply with the potability requi-
rements established by European Directive 98/83 or corres-
ponding national legislation transposing it.
6.1
6 mm
40 mm drain clamp.
Adapter and inlet stop-
cock for 3/8” connec-
tions.
See page 13 for hydraulic diagram.
5
16 mm
The intelligent tap su-
pplied with the equip-
ment has a connection
cable.
The use of a 16 mm drill
bit is recommended for
installation.
To Next Page
Loading...