IONFILTER LATT - Technical Manual: System Features and Limits; Application and Usage of Reverse Osmosis; Reduction of Water Contaminants; Operational Limits for Pump Unit

Manual técnico
1. MAIN FEATURES
APPLICATION
Water treatment
Reverse osmosis
Usage
To improve the characteristics of drinking water (complying with the requirements of the European Drinking Water
Directive 98/83 or its national transpositions in the different Member States of the European Community).
Modifications by reduction or contribution
- Reverse osmosis water treatment is able to reduce concentrations of salts and other substances by high percentages.
- Minimum reduction* of certain compounds and parameters:
Sodium: 90%.
Calcium: 90%.
Sulphate: 90%.
Chloride: 90%.
Total hardness: 90%.
Conductivity: 90%.
* Depending on the characteristics of the water to be treated (at the exit of the membrane). These values may
vary depending on the type of post-filter incorporated in the equipment and/or regulation of the mixing valve (if
incorporated).
2. PRECAUTIONS
ATTENTION: the equipments ARE NOT WATER POTABI-
LIZERS. If the water to be treated comes from a public
supply (and therefore complies with current legisla-
tion), this equipment will substantially improve the quality
of the water.
ATTENTION: If the water to be treated does not come
from a public supply network or originates from an
unknown source, it will be necessary to carry out a
physical-chemical and bacteriological analysis of the water
to ensure its correct potabilisation by applying the techni-
ques and equipment appropriate to each need, PRIOR TO
THE INSTALLATION of the equipment. Contact your distribu-
tor for advice on the most suitable treatment for your case.
TECHNICAL MANUAL
FOR REVERSE OSMOSIS EQUIPMENT
OPERATIONAL LIMITS
PUMP UNIT
Pressure (max./min.):
TDS (max.):
Temperature (max./min.):
Hardness (max.):
4 bar - 1 bar (400kPa-100kPa) .
1500ppm.
38 ºC - 5 ºC.
15 ºHF. **
ATTENTION: If you have any questions regarding the installation, use or maintenance of this equipment, plea-
se contact your dealer’s technical support service ( S. A. T.).
2.1 CONDITIONS FOR THE CORRECT OPERATION OF THE
EQUIPMENT
- The equipment should not be supplied with hot water
(T>38ºC).
- The ambient temperature should be between 4º and 45ºC.
- For water with salinity higher than 1500 ppm consult your
distributor.
- It is recommended that the water to be treated be decal-
cified or with a maximum hardness of 15 ºHF so as to obtain
optimum performance from the equipment.