Ionic Pro TURBO - Operating the Ionic Pro Turbo Air Purifier; Getting Ready for Operation; Controls and Settings Overview; Selecting Operating Settings

Getting Ready
Locate a level surface on which to place Ionic Pro
Turbo
®
ionic air purier and a grounded 120v
outlet. (Follow warnings described in the “SAFETY INSTRUCTIONS” section of this manual.) Position
your Ionic Pro
Turbo
®
ionic air purier at least one foot (12 inches) from the wall. Plug in the unit.
You are now ready to turn on your Ionic Pro
Turbo
®
ionic air purier!
1. ON/OFF Button
A LOW –output indication light (LOW)
B MEDIUM –output indication light (MED)
C HIGH –output indication light (HI)
D CLEAN –indication light (CLEAN)
2. CLEAN –wire cleaning mechanism
3. OPEN –main door button
4. CLEAN –Indication light
OpErATiNG THE iONiC prO TurBO
®
Air puriFiEr
Controls/Settings
1. ON/OFF BUTTON Turns unit on and off.
A LOW –This is the most cost-effective setting. Ideal for medium sized rooms, where windows
& doors rarely open.
B MED –Recommended for medium to large-sized rooms.
C HI –This maximum output setting is recommended for medium to large rooms and/or areas
exposed to heavy dust.
D CLEAN –This red light goes on when your Ionic Pro
Turbo
®
ionic air purier needs to be
cleaned, or the unit is experiencing some other
problem. See “TROUBLE-SHOOTING” section.
Selecting Settings
1. Set up the Ionic Pro
Turbo
®
ionic air purier as
described in “Getting Ready”.
2. Press the ON/OFF button to activate your
ionic air purier and get ready to enjoy clean,
ionized air.
3. The Ionic Pro
Turbo
®
ionic air purier
automatically defaults to the HI (high/maximum
output) setting whenever the unit is turned on.
4. Just press the ON/OFF button one more time to
select the MED (medium) output setting and press
the ON/OFF button once again if you wish to select
the LOW output setting.
5. Press the ON/OFF button a fourth time to turn
the unit off.
6. The indicator LEDs light up to indicate your current
setting (LOW, MED, HI).
Clean Light:
The red CLEAN light will turn on and the unit will shut
down if cleaning is overdue or AC input is unstable.
The Ionic Pro
Turbo
®
ionic air purier’s collection blades
must be cleaned after every month of use and the
internal ionizing wires must be cleaned at the same
time. (See “CLEANING & MAINTENANCE” for full
directions.) Once the collection blades are properly
cleaned, normal operation should resume.
OpErATiNG THE iONiC prO TurBO
®
Air puriFiEr
76