I
TROUBLESHOOTING
The following conditions are normal:
1. The fan is still running about 2 minutes after turning off the the unit.
2. The unit works within room temperature about 1~40ºC. It may stop operation
out of this range or when the air inlet or outlet is covered. (The "CHECK" LED light
will illuminate)
3. The unit includes heater function that could increase the room temperature.
If your Dehumidifier stops working or "CHECK" LED illuminates,
please check the following items first.
When the unit fails to run:
Is power cord unplugged or the power off?
Is "FULL" light on? Check the bucket is well in position?
Check and replace the bucket. Ensure unit is on a level and flat surface.
When the performance seems poor:
Is there any door or window open?
Is steam being generated in the room?
Is the room too big?
Is the filter dirty? Clean it. Refer to the filter cleaning instructions.
Is the inlet or the outlet covered?
When noise occurs:
Is the unit on a horizontal flat and level surface? Move and reset the unit.
Is the air filter dirty? Clean the filter.
NOTE:
1. If the "CHECK" LED illuminates, turn off the unit, unplug from the power socket,
check and clean the filter. If it is dirty, remove any obstacle that covers the air inlet
or outlet, and wait for at least ten minutes before plugging in and switching back on.
2. Please contact Andatech at 1300 800 200 if the problem continues.
Do not try to repair it by yourself, as this could cause an electrical shock and
void your warranty.
Try the laundry mode operation and let it run in this mode for a day.
Is the unit covered?
Is the unit positioned at the required minimum distances away from walls or objects?
(See page 6 Unit Setup)
11
To Next Page
Loading...
