IOTAVX AVXP 2-840 - User Manual

AVXP 2-840
User Manual
Version 1.0
English: From page 1
Deutsch: Ab Seite 6
SAFETY
1. Read this user manual.
2. Keep these operating instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this device near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Operate the device only in accordance with the
manufacturer's instructions.
8. Do not place the device near any heat sources such as radiators, heaters, stoves, or other
devices (including amplifiers) that produce heat.
9. Protect the power cord from being pinched, particularly at convenience receptacles and the
point where it exits from the apparatus.
10. Only use accessories specified by the manufacturer.
11. For use only in combination with the stand, tripod, bracket, or table specified by the
manufacturer, or sold with the device. If a rollable pad is used, use caution when moving the
cart/equipment combination to avoid injury from tipping over.
12. Unplug the device during thunderstorms or when unused for a long period of time.
13. Leave all maintenance work to qualified service personnel. Servicing is required when the
device has been damaged in any way, e.g. if a power cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain
or moisture, does not operate normally, or has been dropped.
14. For power supply information, see the manufacturer's instruction manual. Note that different
operating voltages may require the use of different power cords and/or mounting plugs.
15. Do not install the device in an unventilated rack.

Summary

Safety Precautions

General Safety Instructions

Essential safety guidelines for operating the device, covering warnings and handling.

Product Description

Front Panel Overview

Details the front panel features, including the POWER button.

Rear Panel Components

Describes rear panel connectors such as XLR/RCA inputs, outputs, trigger, and IEC connector.

Basic Operation

Powering the Device On and Off

Instructions for turning the device on, entering standby mode, and trigger operation.

Standby Button States

Explains the LED indicators for standby mode, operational status, and protective circuit activation.

Customer Support

Contact Information

Provides contact details for technical assistance and customer service.

IOTAVX AVXP 2-840 Specifications

General

Type	Power Amplifier
Channels	2
Gain	32dB
Frequency Response	20Hz - 20kHz
Total Harmonic Distortion (THD)	<0.1%
Signal to Noise ratio	>110dB (A-weighted)
Input Sensitivity	1.4V
Damping Factor	>200
Signal-to-Noise Ratio	>110dB (A-weighted)
Input Impedance	20kΩ (balanced), 10kΩ (unbalanced)