What to do if my IOTAVX SA 3 sound cuts off?
If the sound cuts off or there's no sound even when the power is on, it might be because the speaker impedance is lower than what's recommended, causing the amplifier to overload. To fix this, turn off the power, then turn it back on. After that, either reduce the volume or switch to the correct 4/8-ohm speakers.
Why does my IOTAVX Amplifier have low bass response?
A low bass response from your IOTAVX Amplifier could be due to reversed speaker polarity (+/-). Ensure that all speakers and speaker wires are connected with the correct polarity.
What to do if sound is only heard from one channel on my IOTAVX SA 3?
If you're only hearing sound from one channel on your IOTAVX Amplifier, it's possible that one of the input cords is disconnected. Please ensure that all input leads are properly connected.
How to fix reversed left/right speakers on IOTAVX SA 3?
If the left and right speakers are reversed on your IOTAVX Amplifier, it's likely that the speakers are connected incorrectly. Check the speaker connections and reconnect them as needed.
What to do if IOTAVX Amplifier sound cuts off when listening?
If the sound cuts off or there's no sound even when the power is on, it might be due to the speaker impedance being lower than recommended, overloading the amplifier. To resolve this, turn off the power, turn it back on, and then either reduce the volume or switch to the correct 8-ohm speakers.
Why is there low bass response from my IOTAVX Amplifier?
A low bass response could be caused by reversed speaker polarity (+/-). Inspect all speakers and speaker wires to ensure they have the correct polarity.
What to do if sound is only heard from one channel on IOTAVX Amplifier?
If sound is only coming from one channel, it may be because one of the input cords is disconnected. Ensure that you connect the input leads properly.
To Next Page
General
