SA 3 Owner Manual 11
Troubleshooting
To determine any problem with your integrated power amplifier, always check the most obvious possible causes
first. If any problems remain after you have checked the items below, please consult your nearest Authorized
Dealer or Authorized IOTAVX Service Center.
If you experience any of the following difficulties while using the system, use this troubleshooting guide to help
remedy the problem before requesting servicing. Should any problems persist, consult your nearest authorized
dealer or authorized Service Agent.
If the unit does not operate normally due to external influence such as static electricity, disconnect the power
plug from the wall outlet and insert again to return to normal operating conditions.
When listening to the music in stereo.
Left/right speakers reversed.
Speakers are connected incorrectly.
Check, and reconnect as required.
Sound is only heard from one
channel.
One of the input cords is
disconnected.
Sound cuts off when listening or no
sound even though power is ON.
Speaker impedance is lower than
recommended for this unit,
therefore overloading the Amplifier.
After turning off the power and
then turning it on again, reduce
the volume or change to the
correct 4/8-ohm speakers.
Speaker polarity (+/-) is reversed.
Check all speakers and speaker
wires for correct polarity.
To Next Page
Loading...
