How to factory reset Ip.Access nano3G S4 AP and nano3G S8 AP Wireless Access Point?
To perform a factory reset on your Ip.Access nano3G S4 AP and nano3G S8 AP Wireless Access Point, use a thin rod to press and hold the reset button for more than 5 seconds.
How to factory reset Ip.Access nano3G E8 AP Wireless Access Point?
To perform a factory reset on your Ip.Access nano3G E8 AP Wireless Access Point, press and hold the reset button for more than 5 seconds.
What to do if Ip.Access nano3G E8 AP Wireless Access Point does not start up?
If your Ip.Access nano3G E8 AP Wireless Access Point does not start up, make sure that the power-over-Ethernet inserter is a POE+ unit. Also, verify that the Ethernet cable from the POE+ inserter is plugged into the correct socket (LAN1). If you are using a DC power supply instead of POE+, check that the power supply is a 12V supply with the correct polarity.
Why does my Ip.Access Wireless Access Point have backhaul network connection problems?
Ensure that the DHCP service is enabled on the broadband router to resolve backhaul network connection problems with your Ip.Access Wireless Access Point.
General| Model | nano3G S4 AP |
|---|---|
| Category | Wireless Access Point |
| Manufacturer | Ip.Access |
| Technology | 3G |
| Cell Coverage | Up to 2 km |
| Coverage | Up to 2 km |
| Max Users | 32 |
| Antenna Type | Internal |
| Power Supply | PoE (Power over Ethernet) or AC adapter |
| Ethernet Ports | 1 |
| Humidity Range | 5% to 95% (non-condensing) |
To Next Page