How to factory reset Ip.Access nano3G S4 AP and nano3G S8 AP Wireless Access Point?
To perform a factory reset on your Ip.Access nano3G S4 AP and nano3G S8 AP Wireless Access Point, use a thin rod to press and hold the reset button for more than 5 seconds.
How to factory reset Ip.Access nano3G E8 AP Wireless Access Point?
To perform a factory reset on your Ip.Access nano3G E8 AP Wireless Access Point, press and hold the reset button for more than 5 seconds.
What to do if Ip.Access nano3G E8 AP Wireless Access Point does not start up?
If your Ip.Access nano3G E8 AP Wireless Access Point does not start up, make sure that the power-over-Ethernet inserter is a POE+ unit. Also, verify that the Ethernet cable from the POE+ inserter is plugged into the correct socket (LAN1). If you are using a DC power supply instead of POE+, check that the power supply is a 12V supply with the correct polarity.
Why does my Ip.Access Wireless Access Point have backhaul network connection problems?
Ensure that the DHCP service is enabled on the broadband router to resolve backhaul network connection problems with your Ip.Access Wireless Access Point.
Specific site requirements for the nano3G S4 AP model.
Details power consumption and connection options for S4 AP.
Specific site requirements for the nano3G S8 AP model.
Details power consumption and connection options for S8 AP.
Specific site requirements for the nano3G E8 AP model.
Details power consumption and connection options for E8 AP.
Setting up the terminal with static IP for AP connection.
Finalizing the commissioning process and bringing the AP online.
Procedures for installing the nano3G S4 AP hardware.
Instructions for unpacking the S4 AP unit and accessories.
Configuring the S4 AP for AP Management System connection.
Procedures for mounting the S4 AP on a stand, wall, or splitter.
Procedures for installing the nano3G S8 AP hardware.
Instructions for unpacking the S8 AP unit and accessories.
Configuring the S8 AP for AP Management System connection.
Procedures for mounting the S8 AP on a stand, wall, or splitter.
Procedures for installing the nano3G E8 AP hardware.
Instructions for unpacking the E8 AP unit and accessories.
Configuring the E8 AP for AP Management System connection.
Detailed steps for wall mounting the E8 AP.
Verifying and updating the AP's software version.
Procedure to download and install new software.
Final steps to activate the AP for service.
Procedure to reset the AP to factory default settings.
Factory reset procedure for S4 and S8 AP models.
Factory reset procedure for the E8 AP model.
General| Brand | Ip.Access |
|---|---|
| Model | nano3G S8 AP |
| Category | Wireless Access Point |
| Language | English |
To Next Page