nano3G AP Installation Manual Installation Overview and Requirements
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 17
2.5.3 nano3G E8 AP IP Bandwidth Requirements
At maximum capacity, a nano3G E8 AP will require:
• Downlink: at least 7Mbps
• Uplink: at least 1Mbps
This will deliver up to 8 voice calls and HSDPA services up to 7.2 Mbps.
Note: The HSDPA rate of 7.2Mbps is the air-interface rate on Uu. The downlink rate needed to
support this is lower. The uplink assumes a maximum load of 8 UEs each with 64Kbps PS
bearers. Voice traffic has negligible impact.
2.5.4 nano3G E8 AP Installation Tool Requirements
• To mount the bracket onto the wall:
• 6 pan head screws, size No. 6 (approx 3.5mm (0.14in) in diameter) – 4 for
the nano3G E8 AP, 2 for the POE+ adapter
Note: No screws are supplied to mount the AP or the POE+ unit.
• Wall plugs if required.
• Suitable drills and screwdriver.
To Next Page
Loading...