nano3G AP Installation Manual Pre-Provisioning a nano3G AP
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 20
3.1.3 Optional - Load an AP Configuration File
7) Click Next and the File Selection page of the wizard will appear:
Optionally use this page to load a configuration file for the AP. The four options for
file sources are:
• Do not load a file - no configuration file will be loaded - if preferred, it is
possible to load a configuration file later using the Load Attributes Wizard
• Local file - a configuration file stored on the local computer running the
OMC-R Client
• Server file - a configuration file saved on the OMC-R server by saving the
attributes from an AP
• Auto backup - a configuration file saved on the OMC-R server automatically
for an AP when its attributes were last changed
Although files can be selected for all three sources, only the item for the selected
radio button will be used on moving to the next page of the wizard. The AP type in
the chosen configuration file must be the same type of AP object as has been
selected for the new site.
For information on preparing an AP configuration file, see section 4.
To Next Page
Loading...