nano3G AP Installation Manual nano3G AP Hardware Installation
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 41
6 nano3G AP Hardware Installation
This section documents the procedures for installing the nano3G AP hardware and physical
connections.
The following hardware variants are described:
• 6.2 nano3G S4 AP Hardware Installation
• 6.3 nano3G S8 AP Hardware Installation
• 6.4 nano3G E8 AP Hardware Installation
Note: If possible, the engineer should stay on site until the AP is brought into service, ready to
make test calls to verify the AP has been configured correctly from the OMC-R.
6.1 Warnings and Regulatory Information
For all warnings and regulatory information, see section 9.
To Next Page
Loading...
Need help?
General
