EasyManua.ls Logo

IPC Eagle CT15 - Draining the Clean Water; Periods of Inactivity; Battery Maintenance and Charging; Charging Procedure

IPC Eagle CT15
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH
16
close the drain hose with the cap. Check that it is tightly closed and replace the hose in
its housing.
You are then ready to wash and dry again.
6.10. Draining the clean water
! DANGER
Use suitable personal protection devices.
Drain the water with the machine disconnected from the power supply.
To empty the tank:
move the machine near a drain;
remove the cap (fig. G, ref. 1);
when the detergent tank is completely empty, replace the cap (fig. G, ref. 1).
i INFORMATION
The water and detergent solution can also be used to wash the dirty water tank.
7. PERIODS OF INACTIVITY
If the machine is not used for some time, remove the squeegee and brush (or drive disk),
wash them and put them away in a dry place (preferably in a bag or wrapped in plastic
film) away from dust.
Make sure the tanks are completely empty and perfectly clean.
Disconnect the machine from the power supply (depending on the model, unplug from the
mains or disconnect the connector from the battery wiring).
Battery models: charge the batteries completely before storing them. During long
periods of inactivity, you should charge the batteries regularly (at least once every two
months) to keep them constantly at maximum charge.
IMPORTANT
If you do not charge the batteries regularly, they may be irrevocably damaged.
8. BATTERY MAINTENANCE AND CHARGING
! DANGER
Do not check the batteries by sparking.
The batteries give off flammable fumes. Put out all fires and hot embers before
checking or topping up the batteries.
Perform the operations described above in a ventilated room.
To avoid permanent damage to the batteries, do not run them down completely.
Remember that when the corresponding red light (fig. C, ref. 2) flashes on the control
panel, you must charge the batteries.
8.1. Charging procedure
if the machine does not have an on-board charger, connect the external battery charger
connector to the battery wiring connector.
if the machine has an on-board battery charger, connect the on-board battery charger
power cable (fig. H, ref. 1).

Table of Contents

Other manuals for IPC Eagle CT15

Related product manuals