GB
The appliance must be used exclusively by persons trained in its use and/or who have demonstrated their ability
and have been expressly instructed to use the appliance.
The machine must not be used by minors.
The machine must not be used for purposes other than those for which it was expressly designed. Scrupulously
respect all safety standards and conditions applicable to the type of building in which the machine is to be opera-
ted (eg: pharmaceutical companies, hospitals, chemicals, etc).
Do not use the machine in places with inadequate lighting or explosive atmospheres, on public roads, in the pre-
sence of dirt hazardous to health (dust, gas, etc) and in unsuitable environments.
This machine is intended for use in commercial applications, such as hotels, schools, hospitals, factories, shops
and oces, or for hire.
The machine is designed for indoor use only. The machine must be kept indoors at all times.
The machine is designed for temperatures of between +4°C and +35°C when in use and between +0°C and
+50°C when not in use.
The machine must be used at altitudes below 2000 m.
The machine is designed to work in a humidity of between 0% and 95%.
Never use or pick up ammable liquids or explosives (e.g. petrol, fuel oil, etc), ammable gases, dry dusts, acids
and solvents (e.g. paint solvents, acetone etc) even if diluted. Never pick up aming or incandescent objects.
Never use the machine on slopes or ramps of more than 2%. In the case of slight slopes, do not use the machine
transversally, always manoeuvre with care and do not reverse. When transporting the machine on steeper ramps
or slopes, take the utmost care to avoid tipping up and/or uncontrolled acceleration. Tackle ramps and/or steps
with the front of the machine raised only.
Never park the machine on a slope.
The machine must never be left unattended with the motor or engine on. Before leaving it, turn the motor or engine
o, make sure it cannot move accidentally.
Always pay attention to other people, children in particular, present in the place where you are working.
Children must be supervised to make sure they do not play with the appliance.
The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concer-
ning use of the appliance by a person responsible for their safety.
Never use the machine to transport people or things or to tow things. Do not tow the machine.
Never rest objects of any weight on the machine for any reason.
Never obstruct ventilation and heat dispersion slits.
Never remove, modify or circumvent safety devices.
Numerous unpleasant experiences have shown that a wide range of personal objects may cause serious acci-
dents. Before beginning work, remove jewellery, watches, ties, etc.
The operator must always use personal protection devices - protective apron or overalls, non-slip waterproof
shoes, rubber gloves, protective goggles and ear protectors and mask to protect the respiratory tract.
Keep the hands away from moving parts.
Never use detergents other than those specied. Follow the instructions on the relative safety sheet. We recom-
mend keeping detergents out of reach of children. In the event of contact with the eyes, wash immediately with
abundant water. If ingested, consult a doctor immediately.
Make sure the power sockets used for the models with cable or battery charger are connected to a suitable earth
system and protected by dierential thermal solenoid switches.
Make sure the electrical characteristics of the machine (voltage, frequency, absorbed power) given on the rating
plate are the same as those of the mains electricity supply. The machine with cable has a three-wire cable and
a three pin earthed plug for use in an appropriate earthed socket. The earth wire is yellow and green. Never
connect this wire to anything other than the earth contact of the socket.
Battery charger: check the power cable regularly for damage; if the power cable is damaged, do not use the
charger. To replace the cable, contact a specialist service centre.
To recharge the batteries, always use the battery charger supplied with the machine.
It is indispensable to respect the battery manufacturer’s instructions and current legislation. The batteries should
always be kept clean and dry to avoid surface leakage current. Protect the batteries from impurities such as
metal dust.
Never rest tools on the batteries as this could cause short circuit and explosion.
When using battery acid, always follow the relative safety instructions scrupulously.
When using cable models, take care not to crush or pull the power supply cable.
While using the machine, make sure the rotating brush does not come in contact with the power cable (cable
powered version).
Check the power cable regularly. If damaged, do not under any circumstances use the machine. Replace it with
one of the same type or contact a specialised service centre (cable powered version).
In the presence of particularly strong magnetic elds, assess the possible eect on the control electronics.
26
To Next Page
Loading...
