IPC CT45 - Combi accessory; Draining the dirty water; Draining the clean water; PERIODS OF INACTIVITY

GB
Operation:
► Turn the function selector to the Carpet position (Fig. R, ref. 1).
► Press the brush button (Fig. C, ref. 4), then with the pump operating, LED on (Fig. C, ref. 6), activate the
brush control lever (Fig D, ref. 1) and press the detergent button (Fig. C, ref. 6) for at least 3 seconds;
the LED will start ashing, the pump will deliver detergent at high pressure (BATTERY version only). To
restore standard delivery pressure, press the detergent button (Fig. C, ref. 6) for at least 3 seconds.
► Start working, the machine must only be used moving backwards.
Combi accessory
The Combi accessory is used for washing in positions that the oor scrubber cannot reach, such as corners, stairs
or around obstacles.
To use the accessory, proceed as follows:
► switch the machine o󰀨.
► lift the cover (Fig. R, ref. 2) and t the Combi attachment in position (Fig. S, ref. 1) with the hole facing
upwards.
► close the cover (Fig. R, ref. 2) on the Combi attachment to lock it in position.
► if installed, turn the function selector to FLOOR (Fig. R, ref. 1).
► activate the suction motor, pressing the suction button (Fig. C, ref. 5) for a few seconds, until the LED
starts ashing; detergent delivery can also be activated by pressing the button (Fig. C, ref. 6).
► holding the accessory, spray the detergent by activating the lever (Fig. S, ref. 2), and rub the oor with
the bristles (Fig. S, ref. 3) to remove the dirt.
► check at all times that the clean water tank is not empty, as operating the pump without water may cause
irreparable damage.
► after having washed the area using the accessory, switch the machine o󰀨.
Draining the dirty water
DANGER
Use suitable personal protection devices.
Drain the water with the machine disconnected from the power supply.
The dirty water tank drain hose is at the back of the machine on the right.
To empty the tank:
► move the machine near a drain;
► detach the drain hose (g. A, ref. 7) from its seat by holding it near the xing spring and pulling horizon-
tally;
► keeping the end of the hose as high as possible and remove the cap;
► lower the end of the hose gradually, controlling the intensity of the ow of water by adjusting the height
from the ground;
► check the amount of dirt left in the dirty water tank and if necessary wash it out;
► close the drain hose with the cap. Check that it is tightly closed and replace the hose in its housing.
► You are then ready to wash and dry again.
Draining the clean water
DANGER
Use suitable personal protection devices.
Drain the water with the machine disconnected from the power supply.
To empty the tank:
► move the machine near a drain;
► unscrew the cap (g. G, ref. 1);
► when the detergent tank is completely empty, screw the cap back on (g. G, ref. 1).
i INFORMATION
The water and detergent solution can also be used to wash the dirty water tank.
PERIODS OF INACTIVITY
If the machine is not used for some time, remove the squeegee and brush (or drive disk), wash them and put them
away in a dry place (preferably in a bag or wrapped in plastic lm) away from dust.
Make sure the tanks are completely empty and perfectly clean.
35