IPC CT51 - SET Button; + and - Buttons; Working; Emptying the Collection Tank

ENGLISH
► Tank release button (g. 10-ref. 1): releases the tank from the
chassis so it can be rotated backwards.
► Head lift pedal (g. 10-ref. 2): raises and lowers the head on
models without actuator.
► Squeegee lift lever (g. 10-ref. 3): raises and lowers the squee-
gee, enabling or disabling the suction motor on the version with
electric drive.
► Instrument panel height adjustment knobs (g. 10-ref. 4):
unscrew the two knobs to adjust the height of the instrument
panel.
► “SET” button (g. 9-ref. 10): when pressed accesses the ma-
chine operating program submenus, in the “Technical menu”
selects the parameter to be modied and conrms the value en-
tered.
► “+” button (g. 9-ref. 9): increases the value in the machine
operating program submenus, in the “Technical menu” selects
the next parameter or increases the value of the selected pa-
rameter.
► Button “-” (g. 9-ref. 8): decreases the value in the machine oper-
ating program submenus, in the “Technical menu” selects the pre-
vious parameter or decreases the value of the selected parameter.
Working
► Insert the electronic key.
► Using the operation selector, select the scrubbing program.
► Activate the drive lever, lower the squeegee and start working.
► In the machines without electric drive, turning the knob (g. 11-ref. 1)
corrects any tendency to deviate from a straight line.
Some useful tips to get the most from your
scrubber drier
In the event of particularly stubborn dirt on the oor, washing and drying can be performed in two separate operations.
Prewashing with brushes or pads:
► Select the Brush operating program.
► Activate the drive lever, start working.
► If necessary, adjust the ow of detergent delivered to the brush; the outlet ow must be metered in relation to the required travel speed; the
slower the machine travels, the less detergent must be delivered.
► Persist when washing particularly dirty points to give the detergent time to perform its chemical action detaching and suspending the dirt and
the brushes time to exert an e󰀨ective mechanical action.
Drying:
► Select the Suction operating program, lower the squeegee.
► Activate the drive lever, start working.
► Pass over the same area washed previously. The result is equivalent to in-depth washing and subsequent ordinary maintenance will take
less time.
Emptying the collection tank
If the tank is full, the display shows the corresponding alarm, see the chapter “Display alarms”; after a few seconds, the suction motor shuts down,
then stop the machine and empty the tank following the instructions shown below. To resume
work, turn the operation selector to the OFF position (reset errors):
► Switch o󰀨 all the machine’s functions.
► Take the machine to the disposal area.
► Unhook the hose from the clip.
► Empty the tank using the hose (g. 12, ref. 1), at the end rinse the tank with clean water.
1
12
1
2
3
4
10
1
11
16