IPC CT51 - Maintenance Instructions; Maintenance - General Rules

ENGLISH
MAINTENANCE INSTRUCTIONS
! DANGER
Never perform any maintenance operations without rst disconnecting the bat-
teries.
Maintenance on the electrical circuit and all other operations not explicitly de-
scribed in this manual must be performed by specialised personnel only, in
compliance with current safety legislation and as described in the maintenance
manual.
! DANGER
Before lifting/rotating the tank to access the compartment, its contents must
rst be emptied, then insert the safety bracket in position to prevent the tank
from accidentally closing again, see chapter “SAFETY INFORMATION”.
Maintenance - General rules
Performing regular maintenance according to the Manufacturer’s instructions im-
proves performance and extends the working life of the machine.
When cleaning the machine, observe the following precautions:
► Avoid using pressure washers. Water could penetrate the electrical compart-
ment or motors leading to damage or short circuits.
► Do not use steam to avoid the heat warping plastic parts.
► Do not use solvents or hydrocarbon based products. These can damage the
cowling and rubber components.
Cleaning the suction motor air lter
Open the dirty water tank lid by releasing the closing level, then remove the lter (g.
15-ref. 1), wash it under running water or using the same detergent as used on the
machine, then dry and reposition the lter. Lift the tank, remove the lter (g. 16-ref.
1), wash it under running water or using the same detergent as used on the machine,
then dry and reposition the lter.
Cleaning the debris container
Open the dirty water tank lid, then empty the debris accumulated in the container (g.
15-ref. 2); if needing to wash the container, remove it by lifting it out and then clean it.
Cleaning the dirty water tank oat
Open the dirty water tank lid, then remove the debris container by lifting it out (g. 15-
ref. 2), turn the oat protector (g. 15-ref. 3) and then clean the oat; make sure that the
oat slides freely on its pin.
Cleaning the water/detergent tank lter
To clean the lter, proceed as follows:
► Unscrew the lter cap (g. 17-ref. 1), remove the lter/hose union (g. 17-ref.
2, then wash under running water or using the same detergent as used on the
machine.
► Replace the lter in its housing, making sure it is correctly positioned and
screw the cover back on.
1
16
1
2
3
15
17
FILTER
1-2
18