IPC SD13 - English

ENGLISH - 2
Contents
1.1 - INTRODUCTION ....................................................................................................EN-3
1.2 - INTENDED USE OF THE MACHINE ....................................................................EN-3
1.3 - NON-INTENDED USE OF THE MACHINE ...........................................................EN-3
2.1 - COMPONENT ASSEMBLY ...................................................................................EN-3
2.1.a - Positioning the handle ................................................................................ EN-3
2.1.b - Electrical machine handle/body connection ...............................................EN-3
2.1.c - Assembling the cable reel supports ...........................................................EN-3
2.1.d - Assembling the brush ................................................................................EN-4
2.1.e - Assembling the pad holder ........................................................................EN-4
2.1.f - Assembling the tank (Optional) ..................................................................EN-4
2.1.g - Assembling the suction unit (Optional).......................................................EN-4
2.1.h - Assembling additional weight (Optional) ...................................................EN-5
2.1.i - Electrical connection ..................................................................................EN-5
3.1 - KNOWLEDGE OF THE MACHINE .......................................................................EN-5
4.1 - ADJUSTING HANDLE TILT ..................................................................................EN-6
5.1 - GUIDE HANDLE .................................................................................................... EN-6
6.1 - OPERATION .........................................................................................................EN-6
6.1.a - Checks before use .....................................................................................EN-6
6.1.b - Starting the machine .................................................................................EN-6
6.1.c - Using the machine ....................................................................................EN-7
6.1.d - Double speed (if present) ...........................................................................EN-7
6.1.e - End of use and turning off .........................................................................EN-7
6.1.f - Transport ...................................................................................................EN-8
7.1 - MAINTENANCE AND CLEANING .......................................................................EN-8
7.1.a - Cleaning the machine ................................................................................EN-8
7.1.b - Emptying and cleaning the water tank (optional) ......................................EN-8
7.1.c - Replacing the brush ...................................................................................EN-9
7.1.d - Replacing the pad holder ..........................................................................EN-9
TROUBLESHOOTING ...................................................................................................EN-10