V1 mini series server instruction manual
- 12 -
After setting, click “SAVE&APPLY”, the system will save and automatically restart to take effect,
and the server will start to run normally.
End here, the configuration of the server has been completed, congratulations on your
becoming a miner.
(2-2) Select “Static” State
(a) Enter the IP address, netmask, gateway, and DNS-Server in turn in the four boxes below, then
click “SAVE&APPLY”.
(b) After the page buffering is completed, the configuration of the server has been completed,
congratulations on your becoming a miner.
Image (Static)
To Next Page
Loading...