iPower SUA4300iD - Starting the Engine (Generator); Select the Fuel Source (Gasoline); Select the Fuel Source (Propane;Lpg)

4. Pull recoil starter twice.
Page 20
2. Add gasoline to the fuel tank.
5. Turn the starting dial switch to the RUN
position.
3. Turn the starting dial switch to the START
position.
4. Pull recoil starter slowly until resistance is felt,
then pull rapidly.
3. Turn the starting dial switch to the START
position.
Select the Fuel Source (Propane/LPG)
1. Connect the LPG gas hose to the propane fuel
source. Connect the small end of the LPG gas
hose to the LPG inlet on generator and then
snug with a wrench to prevent leakage.
2. Fully open the Propane/LPG cylinder knob.
Note: For restarting a warm engine, turn the starting
dial switch directly to the “RUN” position.
Note: For restarting a warm engine, turn the starting
dial switch directly to the “RUN” position.
Pull twice