IPSO HF234 - Technical Remarks on Program Timings; CAM-Timer Program Durations

16
5
Technical remarks
Program time (Machine with CAM-timer)
Remark
In the programs 1 & 2 the pre-wash is installable on 430" or 630" and the main wash installable
on 9' or 12',according to the cabling.
Every time the machine is out of balance during the spin 1 minute is added to the program. (See
electronical repetition system)
Code 10.1126 - 220 V (50Hz with brown CAM-timer)
There are several possibilities according to cabling, microprocessor, type of heating, tempe-
rature control, water level control, etc.... For your information you can find the details of the
programs for a machine with standard programs, boiler fed (without temperature control nor
water level controls).
12345
Hot Warm Synth. 1 Synth. 2 Wool
water inlet cold+warm cold+warm cold+warm cold+warm cold
pre-wash 630" 630" 430" 630" 630"
water drain 130" 130" 130" 130" 1'30"
spin 230" 230" 230" 130" 130"
water inlet warm 33% cold+ 50%cold+  
66% warm 50%warm
main wash 12' 12' 9'  
water drain 130" 130" 130"  
water inlet cold cold cold cold cold
rinse1 2' 2' 2' 2' 2'
water drain 130" 130" 130" 130" 130"
spin 230" 230" 130" 130" 130"
water inlet cold cold cold cold cold
rinse 22'2'2'2'2'
water drain 130" 130" 130" 130" 130"
spin 230" 230" 130" 130" 130"
water inlet cold cold cold cold cold
rinse 3 230" 230" 230" 230" 230"
water drain 130" 130" 130" 130" 130"
low spin 250" 250" 250" 250" 250"
high spin 440" 440"   
delay 30" 30" 30" 30" 30"
tumble 30" 30" 30" 30" 30"
total 4830" 4830" 3650" 2720" 2720"