The mains supply must be fused at 3
amp.
1.8 VENTILATION
If the appliance is installed in a cabinet, it
MUST NOT be used forstorage purposes.
Any ventilation provided for the appliance
during installation MUST NOT be blocked
and a periodic check must be made
to ensure that the vents are free from
obstructions.
1.8.1 Cleaning
Use only a damp cloth and mild detergent
to dean the appliance outer casing.
DO NOT use abrasive cleaners.
1.9 SAFETY
It is essential that the instructions in
this booklet are strictly followed for the
safe and economical operation of this
appliance. The appliance functions as a
fan assisted balanced flue unit.
The flue terminal
MUST NOT BE OBSTRUCTED under any
circumstances. If damaged, turn off
the appliance and consult the installer,
service engineer, or gas supplier.
If it is known or suspected that a fault
exists on the appliance it MUST NOT be
used until the fault has been rectified by
a competent person.
WARNING:
IF A GAS LEAK IS SUSPECTED OR
EXISTS, TURN OFF THE GAS SUPPLY TO
THE APPLIANCE AT THE GAS SERVICE
COCK.
DO NOT OPERATE ANY ELECTRICAL
SWITCHES.
DO NOT OPERATE ANY ELECTRICAL
APPLIANCE.
OPEN ALL WINDOWS AND DOORS. DO
NOT SMOKE.
EXTINGUISH ALL NAKED LIGHTS.
CONTACT THE NATIONA L GAS
EMERGENCY SERVICE IMM EDIATLEY
ON 0800111999.
MECHANICAL TIME CLOCK - Code 8092270
Setting the time
The tim e of day can be set by grasping
the outer edge of the black dial and
turning it in a clockwise direction
un til the correct tim e is in line with
the white pointer.
Setting the "switching time"
The "ON" periods are set by sliding
the blue tappets, adjacent to the
tim e periods required, to the outer
edge of the dial.
The tappets that rem ain at the
centre of the dial w ill be the "OFF"
periods.
N.B.: The smallest switching time
(ON or OFF) is 15 minutes.
- To select "Timed" mode move the
selector switch in the middle of
the d o c k face to the "Q"
position.
- To select "Constant" mode
move the selector switch in the
middle of the do c k face to the
"I"
position.
- To select "OFF" mode move the
selector switch in the m iddle
of the d o c k face to the "0 "
position.
To Next Page
Loading...
