IRiver T6 - Connecting Products; Charging the Product

Connecting Products
Connecting karphones Charging the Product
1. Connect earphones to the Earphone jack. 1. Turn on your PC and connect the T6 to it using the
USB cable provided.
iriver
2. The integrated battery will charge automatically.
= Do not use any USB cable other than the one included with the product.
This may cause a malfunction.
m Check if the product is connected to a high-power USB 2.0 port. Some low-power
USB ports built into certain peripheral devices, such as some types of keyboards
and USB hubs without integrated power may not provide enough power to charge.
= While the PC is switched to standby mode, the product may not be charged.
m Charge the product only at room temperature.
The product may not be charged in extremely hot or cold place.
= The battery will be fully charged within about 3 hours.
(When completely uncharged in Power only Mode)
m The available usage time of charged battery becomes short over time.
= The charging time might be extended if you use the product while charging.
Æ =
=
11 Basic Operations