9 For more information, visit global.irobot.com
EN
1
Cleaning the Sensors, Camera
Window, and Charging Contacts
Cleaning the Mopping Pad Replacing the Wick Cap
Wipe sensors, camera window, and
charging contacts with a clean, dry cloth.
Important: Do not spray cleaning solution
or water onto the sensors or sensor
openings.
HAND WASHING
Thoroughly wash the
pad with warm water.
MACHINE WASHING
Wash using the warm
cycle, then air dry.
Do not tumble dry.
Do not wash with
delicates.
1
2
3
4
Remove pad plate
Remove the wick cap by pulling on the side
rubber tab.
Replace with a new wick cap, pressing
firmly into place to create a tight seal to
prevent leaking.
Reintall pad plate
To Next Page
Loading...
Need help?
General
