iroda SOLDERPRO 120K - User Manual

Questions and Answers

J
Jared DennisJul 28, 2025
What to do if my iroda Power Tool does not ignite?
- A
  Andrea EdwardsJul 28, 2025
  If your iroda Power Tool doesn't ignite, there could be several reasons. First, check if the gas tank is empty and refill it with butane fuel if needed. Also, the fuel pressure might be too high or too low; try adjusting the control lever to a higher or lower position. Avoid pushing the on/off ignition switch too fast. Finally, the orifice connector might be clogged; in this case, clean or replace it with a new orifice assembly.
E
Eric LeonAug 6, 2025
Why does my iroda SOLDERPRO 120K have low gas pressure or a low flame?
- L
  Laura GriffithAug 6, 2025
  A low gas pressure or low flame in your iroda Power Tool can occur due to a few reasons. The orifice connector might be clogged, so try cleaning or replacing it. Cold fuel can also cause this issue; hold the body in your hands to allow the unit to warm up. Lastly, check if the fuel is low and refuel if necessary.
G
Gina HaasAug 17, 2025
How to fix an iroda Power Tool when the tip does not heat up?
- J
  James KleinAug 17, 2025
  If the tip of your iroda Power Tool isn't heating up, it could be due to a few reasons. The catalyst inside the tip housing might be used up, requiring you to replace it with a new tip. Another possible cause is insufficient fuel pressure; try adjusting the control lever to a higher position. Lastly, a clogged orifice connector might be the culprit; clean or replace it with a new one.

Summary

Important Safety Instructions

Safety Warnings and Precautions

Crucial safety guidelines for using the butane soldering iron safely, covering handling, storage, and operational hazards.

Product Description

Component Identification

Identification of key components of the Solderpro 120K soldering iron, including cap, tip, and controls.

How to Use the Solderpro 120 K

Refilling the Gas

Step-by-step instructions for safely refilling the butane gas canister, emphasizing ventilation and correct procedure.

Ignition Procedure

Detailed steps for igniting the soldering iron, including gas flow control and confirmation of heating.

Ignition Warnings

Precautions During Ignition

Critical warnings to avoid injury or damage, such as not touching hot parts or igniting without the tip assembly.

Temperature Adjustment

Adjusting Gas Control

Guidance on using the gas control lever to adjust tip temperature and avoid excessive heat or flare-ups.

Maintenance and Troubleshooting

Changing Tips

Instructions for safely removing and replacing the soldering tip, with a warning about catalyst delicacy.

Cleaning and Replacing Nozzle Assembly

Procedure for cleaning or replacing the nozzle assembly, including specific steps for the orifice connector.

General Cleaning

Recommendations for cleaning the tool's housing using mild soap and water, avoiding harsh chemicals.

Troubleshooting Common Issues

Solutions for common problems like ignition failure, low flame, or the tip not heating up.

Specifications and Warnings

Product Specifications

Technical details of the Solderpro 120K, including dimensions, weight, temperature, and operating time.

Special Warnings

Important warnings regarding California Proposition 65 and transportation regulations for flammable gas products.

iroda SOLDERPRO 120K Specifications

General

Power Source	Butane Gas
Fuel	Butane
Run Time	Up to 120 minutes
Fuel Capacity	28 ml
Ignition	Piezoelectric Ignition

Related product manuals