iroda SolderPRO 150K - User Manual

Questions and Answers

T
tfoxJul 29, 2025
What to do if my iroda SolderPRO 150K does not ignite?
- T
  Tonya CervantesJul 29, 2025
  If your iroda Power Tool doesn't ignite, there could be several reasons. First, check if the gas tank is empty and refill it with butane fuel if needed. Also, the fuel pressure might be too high or too low; try adjusting the control lever to a higher or lower position. Avoid pushing the on/off ignition switch too fast. Finally, the orifice connector might be clogged; in this case, clean or replace it with a new orifice assembly.
C
charleshowellAug 7, 2025
Why does my iroda SolderPRO 150K have low gas pressure or a low flame?
- M
  michellewilsonAug 8, 2025
  A low gas pressure or low flame in your iroda Power Tool can occur due to a few reasons. The orifice connector might be clogged, so try cleaning or replacing it. Cold fuel can also cause this issue; hold the body in your hands to allow the unit to warm up. Lastly, check if the fuel is low and refuel if necessary.
D
David RussoAug 17, 2025
How to fix an iroda SolderPRO 150K Power Tool when the tip does not heat up?
- D
  derekcollinsAug 17, 2025
  If the tip of your iroda Power Tool isn't heating up, it could be due to a few reasons. The catalyst inside the tip housing might be used up, requiring you to replace it with a new tip. Another possible cause is insufficient fuel pressure; try adjusting the control lever to a higher position. Lastly, a clogged orifice connector might be the culprit; clean or replace it with a new one.