iroda SolderPRO 150K - Ignition Warnings; Temperature Adjustment

10
• DonottouchTip,TipHousingorKnurledNutwhileigniting.(Fig.6)
• DonotignitetorchwhenTipAssemblyisnotscrewedon.(Fig.7)
Fig.6 Fig.7
11
• Thetiptemperaturecanbeadjustedbyturning
theGas Control Leverleftorright.(Fig.8)
• Settomid-positionwhensolderingor
brazing.
• Excessivegasow,are-uporcatalystpulsing
redmayoccurwhentheGas Control Leveris
settoohigh.
Fig.8
Mid-Position
IGNITION WARNINGS TEMPERATURE ADJUSTMENT