iroda SolderPRO 150K - How to Use the SolderPro 150 K; Refilling the LEC; Inserting LEC into Torch

HOW TO USE THE SOLDERPRO 150K
6
REFILLING LEC
Insert LEC into Torch
• Useonlyhigh-qualitybutanegas.
• Rellinawell-ventilatedareaawayfromanyignition
sourceandotherpeople.
1. Holdbutanecanisterupsidedownwhenlling(Fig.1)
2. FirmlypresscanisternozzleintoGas Filling Valve.
3. Observefuellevelandstopllingwhen90%Full.
(Gasoverowduringrellingisnormalanddoesnot
indicatealeak)
4. Waitforafewminutesbeforeuse.
1. RemoveChamberCapatbottomoftorch.
2. InsertLECintochamberwithgrayatsidetoward
insideofchamber.
3. DonotforceLECintochamber.ChamberCapwill
properlyseattheLECinchamberwhenscrewedon.
4. ReplaceChamberCap.
Fig.1
Fig.2
Fig.2
(LiquidEnergyCell)
Butane
7