Page 9 of 32
Nuts: M6
Installation Steps
1. Ensure the handle mounting hole fits the base of the mounting holes.
2. Insert the bolt and screw into the nut by hand.
Tighten the nut with an S10 open-end wrench and then tighten the bolt with an S8 open-end wrench.
Before Each Use
Step One: Inspect & Repair
If the pump has been previously used, it must be prepared BEFORE EACH SUBSEQUENT USE.
Read instructions below carefully for inspecting and preparing the pump. Damaged or clogged
equipment could result in leaks or uncontrolled spray.
IMPORTANT SAFETY RULES
Check oil. Before each use, check the oil level and if it’s low, add oil to the proper level.
Turn off engine. Turn off the engine and remove the spark plug cap before cleaning, inspecting,
or servicing the pump.
Guards/shields. Make sure all guards and shields are replaced after servicing the pump.
Replacement parts. If a part needs replacement, only use parts that meet the manufacturer's
specifications. Replacement parts that do not meet specifications may result in a safety hazard or
poor operation of the pump.
To Next Page
Loading...
