EasyManua.ls Logo

IROX EBR606C - Manually (Re-)Register the Remote Sensor; DCF77 Radio Controlled Clock (RCC); Set the Clock

IROX EBR606C
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MANUALLY (RE-)REGINSTER THE REMOTE SENSOR
If the battery is low and needs to be replaced or the communication between the main
unitandremotesensorisinterruptedfor35minutes,theoutdoorreadingdisplays‘--,-’.
It is also possible that your weather station is receiving information from your neigh-
bour which might be using the same frequency and channel.
You can re-register your outdoor sensor manually.
• Removethebatteriesfromtheremotesensorforafewseconds.
• Re-installthebatteriesinthecorrectpolarity.ThetransmissionLED
willash
every2seconds.
• Presstheoutdoorsensorchannelselectbutton
to chose the desired channel
(1,2or3).ThetransmissionLEDwillashevery2secondsasmanytimesasthe
selected channel.
• Pressandholdthe[CH]buttononthemainunitfor2secondstoactivatethe
search mode. A brief beep is audible and a remote sensor channel number (1-3)
startstoash.
• Makesurethattheremotesensorisinstalledwithinrange(maximum50minan
open area).
• Theweatherstationwilldetecttheremotesensorandtheremotesensortempera-
ture will be displayed.
• Pressandholdthe[CH]buttononthemainunitfor2secondstoexitsearchmode.
• Ifnobuttonispressed,searchmodewillautomaticallystopafter2minutes.
DCF77 RADIO CONTROLLED CLOCK (RCC)
TheremotesensorreceivesthetimesignaltransmittedbyPhysikalisch-Technische
Bundesanstalt(PTB)ofGermany.Inaveragethistimedeviateslessthan1second
in2millionyears.PTBtransmitsthetimesignal(DCF77,77.5kHz)continuouslyfrom
MainingennearFrankfurtamMain.Itisexpectedthatthesignalcancoveradistance
of more than 1,000 km from the transmitter. Then the remote sensor transmits the time
signal to the weather station to display the accurate time. However, there are many
environmentfactorsthatmayaffecttheRCCreception(nearbycomputermonitorsor
otherelectronicdeviceslikeTV,metalsurfacesetc.).Pleaseplacetheremotesensor
away from metallic structures and face the transmitter in the direction of Frankfurt a.M.
SET THE CLOCK
IfDCFreceptionfails,oryouwanttosetyourdesiredtime,pleasefollowthesteps
below:
1. Pressandhold[MENU/SETUP]buttonfor2secondstoenterclocksettingmode,
thehourvaluebeginsashingatthefrequencyof1Hz.
2. Press[▲]or[▼]buttononcetoincreaseordecreasethehourvaluebyonehour.
3. Press[MENU/SETUP]buttontoconrmthehourvalue.
4. Theminutessettingmodebeginsashing.
5. Press[▲]or[▼]buttontosetyourdesiredminutevalue.Holdingdowneitherbut-
tonwillincreaseordecreasetheminutesrapidly.Press[MENU/SETUP]buttonto
conrmtheminutevalue.
(ENG)
~26~

Related product manuals