1. Ready to start in just 3 steps!
1) Fasten the PE-SOS2 with the clip to your belt/trouser
waistband in front of your body at hip height.
2) Press the ‘MODE’ key (S1) until ‘STEP/TIME’ appears in the
display (the number of steps is indicated at the top, and the
time at the bottom)
3) Press and hold the key ‘UP/CLR’ (S3) until the display of the
number of steps is set to zero.
-> and off you go
From the display, you can now see the number of steps in
the top line.
For more information on the device, please read through the
instructions for use in their entirety.
TABLE OF CONTENTS
1. Ready to start in just 3 steps! 3
2. Introduction 4
3. Wearing the pedometer properly 6
4. Select a function (MODE) 9
4.1 The function step and time (STEP/TIME) 10
4.2 The function distance and stopwatch (DIST/STW)
11
4.3. The function calories and odometer (KCAL/ODO) 12
4.4. The function target calories and daily cal
(SETCAL/DAYCAL) 13
5. Change of battery 14
6. Care Instructions 15
7. Support 16
To Next Page
Loading...
Need help?
General
