IrriGreen 2 - Controller Terminals Overview; Input Terminals; Output Terminals

Quick Install Guide
14
15
End Plug
Sprinkler
Cable
End Plug
Step 10: Connect Irrigreen Cables to Head
Click or scan for
Step 10 video
If this is the last sprinkler on the
line, put an end plug on the open
connector to keep connector dry.
If there are more sprinklers on this
line, connect a sprinkler cable to the
larger connector end to “daisy chain”
to the next sprinkler on the line.
End Plug
with CableLok
1. Align arrows on connectors
2. Push connectors together unl they boom out
3. Place CableLok Top over connectors
align ridge with corresponding ridge on connector
4. Snap CableLok Top down into place 5. Align and Snap CableLok Boom into place
To remove: use
sloed screwdriver
Align arrows
Align ridges
CableLok
Larger End
Smaller End
Align
Arrows