IrriGreen 2 - Controller Power Connection; Transformer Specifications; Wiring the Transformer

16
1. Align arrows on connectors
2. Push connectors together unl they boom out
3. Place CableLok Top over connectors
align ridge with corresponding ridge on connector
4. Snap CableLok Top down into place 5. Align and Snap CableLok Boom into place
To remove: use
sloed screwdriver
Align arrows
Align ridges
CableLok
Step 11: Use CableLok Over Connectors
CableLoks help prevent any leakage or
corroding. Use CableLok over all connectors.
1. Align arrows on connectors. Push
connectors together until they bottom out.
2. Place CableLok Top over
connectors and align ridge with
corresponding ridge on connector.
3. Snap CableLok Top down into place.
4. Align and Snap CableLok Bottom
into place.
1. Align arrows on connectors
2. Push connectors together unl they boom out
3. Place CableLok Top over connectors
align ridge with corresponding ridge on connector
4. Snap CableLok Top down into place 5. Align and Snap CableLok Boom into place
To remove: use
sloed screwdriver
Align arrows
Align ridges
CableLok
1. Align arrows on connectors
2. Push connectors together unl they boom out
3. Place CableLok Top over connectors
align ridge with corresponding ridge on connector
4. Snap CableLok Top down into place 5. Align and Snap CableLok Boom into place
To remove: use
sloed screwdriver
Align arrows
Align ridges
CableLok
1. Align arrows on connectors
2. Push connectors together unl they boom out
3. Place CableLok Top over connectors
align ridge with corresponding ridge on connector
4. Snap CableLok Top down into place
5. Align and Snap CableLok Boom into place
To remove: use
sloed screwdriver
Align arrows
Align ridges
CableLok
Click or scan for
Step 11 video