7
Setting the PIN
After connecting the receiver, it is necessary to set the PIN in the transmitter and receiver. Set the PIN in the transmitter rst.
To Set the PIN in the Handheld Transmitter:
1. Press the red MODE/PWR button to turn on the remote transmitter.
2. Press the SETUP button twice; “SET PIN” appears in the upper left corner of screen.
3. Use the UP or DOWN arrow button the set the rst digit of the PIN number on the left.
4. Use the RIGHT arrow button to move to the second digit.
5. With the UP or DOWN arrow button set the second PIN number. Press RIGHT.
6. Repeat the steps to set the other numbers in your 4-digit PIN.
7. When the 4-digit PIN is set, press the ENTER button to save the PIN.
To Teach the PIN to the Mini-Receiver, (not Climate Logic’s Receiver):
1. Turn Remote ON with the red MODE/PWR button.
2. Press the SETUP button twice; “SET PIN” screen appears with the PIN displayed.
3. Hold down the only button on the mini-receiver for more than 8 seconds.
4. When the green light on the receiver begins ashing rapidly, release the receiver’s button (intermittent ashing will
continue) and press the ENTER button on the Remote. The red light on the Receiver will blink briey.
To Next Page
Loading...
Need help?
General