9
General Operation
To Power the Remote Transmitter:
1. Press the red MODE/PWR button to turn on.
2. Press and hold MODE/PWR button (about two seconds) to turn o.
Note: Turning o the transmitter does not turn o a station in operation. (See Stop All Watering to stop an active station.)
Automatic Power Down of Transmitter
To extend battery life, ve minutes of button inactivity will shut o the transmitter.
To Set the Number of Stations:
To save time using the remote, set the number of stations in the transmitter to match the number of stations on the con-
troller. For example, for a 12-station controller, set the transmitter to a station maximum of twelve also. If only using 8 of the
12, set max to 8.
1. Press the SETUP button once to view the Max Station screen.
2. Press either the UP or the DOWN arrow buttons to set the desired maximum station number.
3. With the desired number displayed, press ENTER .
To Start Program “A” or “B” or ”C” (not functional in all controllers):
1. In manual station mode, press the UP arrow button to go beyond the highest station. “P-A” appears. Press the UP
button again for “P-B” or again for “P- C”.
2. With the desired Program displayed, press ENTER for a sequential station run.
Note: The “Manual Program” feature does not work with MC-E controllers.
A remotely started program runs continuously.
To Next Page
Loading...
Need help?
General