Need help?Do you have a question about the Irritrol Dial-7 and is the answer not in the manual?
General| Watering Programs | 3 Independent Programs |
|---|---|
| Program Start Times | 3 Start Times per Program |
| Rain Delay | Yes |
| Display Type | LCD |
| Cycle Option | Yes |
| Manual Watering | Yes |
| Weight | 1.5 lbs |
| Power Source | 24 VAC |
| Mounting | Wall Mount |
| Battery Backup | 9V battery |
Choose a suitable outdoor location and install the controller vertically on a flat surface or pedestal.
Connect the power supply, following electrical codes and avoiding inductive loads for safe operation.
Connect solenoid wires, pump relay, and sensors to the terminal strip, ensuring proper hookups.
Perform valve tests and understand circuit breaker function to diagnose wiring issues.
Understand the 9V battery backup and install/use sensor ports for enhanced control.
Develop a watering plan, set current time/day, and erase prior programs for a fresh start.
Program duration for each station and select watering days using the 14-day schedule.
Set up to three start times daily and utilize Program B for a separate watering schedule.
Manually turn stations on or off, overriding programmed schedules for immediate needs.
Temporarily suspend watering with Rain Off or run cycles semi-automatically.
Adjust watering times by a percentage (0-255%) to conserve water or meet seasonal needs.
Utilize six-day schedules, program water time in seconds or hours for specific flexibility.
Repeat watering cycles for a specified time, allowing for unlimited start times using loop start/stop.
Address issues like valves not turning on, controller skipping cycles, or no display by checking common causes.
Resolve "FUSE" displays, "Err 1/Err 2" codes, and valve-stay-on problems by checking wiring and settings.
To Next Page