Need help?Do you have a question about the Irritrol MC-36E and is the answer not in the manual?
General| Brand | Irritrol |
|---|---|
| Model | MC-36E |
| Category | Controller |
| Language | English |
Instructions for routing and connecting valve control wires to the controller.
Steps for safely connecting the controller to a 120 VAC power source.
Assigning specific stations and their watering durations to a program.
Defining up to eight start times for each watering program.
Setting the watering days for programs using days of the week or exclusion days.
Adjusting global watering percentage to conserve water based on seasonal needs.
Erasing all programmed irrigation programs, resetting them to default.
Resetting the entire controller to its factory default settings.
Temporarily suspending automatic watering for a set number of days.
Activating a single station manually until turned off or midnight.
Installing the flow meter and routing sensor wires to the controller.
Configuring the controller to recognize the installed flow sensor and its parameters.
Setting up protection against unscheduled flow by using Station 1 as a flow alarm.
Selecting the correct model and size code for the installed flow sensor.
Calibrating the controller to learn the normal flow rate for each station.
Defining acceptable flow limits to detect overflow conditions.
Setting the delay before reading flow to allow system stabilization.
To Next Page