Need help?Do you have a question about the Irritrol MC-6 PLUS and is the answer not in the manual?
General| Number of Zones | 6 |
|---|---|
| Display Type | LCD |
| Stations | 6 |
| Expandable | Yes |
| Number of Programs | 3 |
| Voltage | 24VAC |
| Start Times per Program | 4 |
| Cycle and Soak | Yes |
| Sensor Input | Yes |
| Backup Memory | Yes |
| Program Start Times | 4 per program |
| Maximum Run Time | 240 minutes |
| Power Source | 24V AC |
| Mounting | Wall |
| Number of Start Times | 4 |
| Watering Days | 7-day |
| Enclosure | Indoor/Outdoor |
Allows simple, single-entry adjustment of watering run times.
Choosing an appropriate location for the controller, away from spray and near power.
Instructions for wall mounting or pedestal installation of the controller.
Steps for safely connecting the controller to the power supply.
Procedure for connecting the sprinkler valve wires to the controller.
How to verify that valve wiring is correct before powering on.
Guidance on connecting a pump via a relay to the controller.
Instructions for connecting rain-off and start sensors.
Details how the controller detects and handles short circuits.
Steps to input the current hour and minute into the controller.
Procedure to set the current day of the week for accurate scheduling.
How to define the run time for each station in a program.
Setting the specific times when watering cycles will begin.
Temporarily stopping all automatic watering cycles due to rain.
Adjusting watering times by a percentage (0-255%).
Solutions for when no stations activate automatically.
Troubleshooting common error messages shown on the display.
Diagnosing and resolving issues where a valve remains active.
Steps to troubleshoot a station that fails to activate.
Understanding and resolving 'Fuse' indications from the circuit breaker.
To Next Page