Daily:
01. Lubricate attachment quick coupling.
02. Check engine oil level (see separate manual for the engine).
03. Clean air filter, if necessary (see separate manual for the engine).
04. Check coupler play and adjust, if necessary (Figure 8).
Every 20 hours or sooner, if necessary:
01. Clean air filter (see separate manual for the engine).
02. Change engine oil (see separate manual for the engine).
03. Lubricate steering rod (3 grease gun strokes per grease nipple [5 x]).
04. Remove attachments and grease nipple at the PTO (3 grease-gun strokes) (Fig. 7/1)
After the first 50 hours of operation:
01. Remove casing and blow out the inside of the machine with compressed air.
02. Check hydraulic oil level.
03. Remove attachment, lubricate the attachment quick coupler with a grease brush, and mount
attachment again.
04. Lubricate steering rod (3 grease-gun strokes per grease nipple [5 x]).
05. Lubricate Bowden cables.
06. Check engine for leaks.
07. Change oil in the speed reduction gears (engine must be at operating temperature).
08. Replace hydraulic oil filter (Figure 6/4).
ATTENTION!
Collect waste oil in a suitable container and dispose of it according to the local recycling regulations. Never
allow oil to drain into the ground or into the sewer system.
Every 50 hours:
01. Remove casing and blow out the inside of the machine with compressed air.
02. Check the hydraulic oil level.
03. Remove attachment, lubricate the attachment quick coupler with a grease brush, and mount
attachment again.
04. Lubricate steering rod (3 strokes per grease nipple [5 x]).
05. Lubricate Bowden cables.
06. Check the engine for leaks
After every 500 hours, but at least 1 x per year:
01. Change the oil in the speed reduction gears (see "After the first 50 hours").
02. Change the hydraulic oil.
03. Replace the hydraulic oil filter.
To Next Page
Loading...