TROUBLESHOOTING
No Power
Check and make sure whether the fuse
is
blown,
replace fuse with proper value if necessary.
Some errors occur
in
the
LCD
or no function when
pressing the button.
Turn off the unit and restart the unit again. Use
Factory Default Restart.
Poor radio reception or static.
Antenna may not be the proper length. Make sure
the antenna is
fully
extended. Antenna may be
broken. Replace antenna.
The broadcast signal
is
too weak.
The antenna is poorly grounded. Check and make
sure the antenna is properly grounded at it's
mounting location.
Disc cannot
be
loaded
Disc is loaded
in
the machine. Clear the disc by
pressing eject
No Picture.
The Video line from the main unit to the TV is not
connected properly. Check connections.
Improper
setting
of
the TV SYSTEM. Set the TV
SYSTEM to
"NTSC",
according to the
connected television.
22
Disc error appears.
The disc may be damaged or dirty.
Clean disc and retry.
When there
is
no color
on
video.
Turn off the unit and restart the unit again.
Use Factory Default Restart.
FACTORY
DEFAULT RESTART
Press and hold
POWER
button for 5 seconds - Unit will
shut off. Restart unit by pressing the
ON
button. Factory
defaults
will
be
reset with this type of restart.
NOTE:
If
any of the problems persist after check list has been
made, consult your nearest service dealer.
Never attempt to disassemble your unit by yourself.
To Next Page
Loading...