SCMA54,60
88
WARNING:
・As soon as the PTO switch is pushed
to the ON position, the mower blades
start rotating and eject cut grass or
stones through the discharge opening.
Consequently, before operating the PTO
switch, make sure that there is no people,
animals, or physical properties like
buildings, cars, etc. within a range where
ejected grass or stones may reach.
・The mower blades should be turned only
on turf or grassland with the mower deck
lowered.
h. Turn the throttle lever to the high speed position
to raise engine speed.
i. As the HST forward travel pedal is depressed
gradually, the front mower starts to travel.
CAUTION : Be sure to start moving at
sufficiently low speeds and increase
travelling speed gradually.
IMPORTANT: The radiator screen should be kept clean.
Never keep on operating with clogged
screens, or the engine may be overheated,
which may result in engine seizure.
j. The front mower is equipped with a system called
"Up-stop" device, which stop the mower blades
when the mower deck is lifted up while the front
mower is travelling on rugged terrain with the
mower PTO.
DANGER:
・The up-stop device is installed to prevent
accidents. Never attempt to activate the
system by operating the mower lift lever.
・The mower blades of the mower deck
stopped by this device are subject to
turning very slowly even when the mower
deck is lifted up, which is very dangerous
and may shorten the service life of the
drive shaft.
k. Before travelling at a constant speed set by
the cruise lever, be sure to be familiar with the
operation of the cruise system.
4. CLEANING A MOWER DECK CLOGGED WITH
GRASS
When mowed grass is not ejected from the mower deck,
the inside of the deck is most probably clogged with
grass. Stop operation immediately and remove clogging
grass.
(1) Mower deck
a. Push the mower and blower PTO switch to the OFF
position and shift the mower lift lever backward to
raise the mower deck in the highest position.
b. Stop the engine.
c. Remove clogged grass completely.
CAUTION :
Exercise sufficient cares not to be cut by
the blades.
d. Check the blades for deformation or damage and
make sure that the blades turn smoothly by hand.
e. Referring to the paragraph for blade replacement,
turn back the mower deck.
1
To Next Page
Loading...
