EasyManua.ls Logo

Iseki SF370 - User Manual

Iseki SF370
92 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
MODELS:
SF310
SF370
SF310
SF370
Operator’s Manual
ENGLISH
-Original Instructions-

Table of Contents

Questions and Answers

  • C
    christopher69Aug 19, 2025
    Why Iseki SF370 Lawn Mower starter motor does not work?
    • J
      James KellyAug 19, 2025
      The starter motor may not work because the master brake pedal is not depressed. Make sure to depress it fully. Also, check that the PTO switch is in the OFF position. If the battery is not fully charged, charge it. Poorly connected battery terminals can also be the cause; clean the terminal posts and connect them securely. Other potential causes include defective internal wiring in the connector, a defective safety switch of seat, a broken starter switch, or a broken starter motor, in which case consult your dealer.
  • J
    John HooperAug 21, 2025
    What to do if my Iseki SF370 engine is overheated?
    • J
      Jason Hoffman MDAug 21, 2025
      If your Iseki Lawn Mower engine is overheating, first check the engine coolant level and replenish if it's low. Ensure the fan belt is properly tightened. Clean any clogs from the radiator fins and screen, and replenish the engine oil to the upper limit if the level is low. Also, clear any clogged air-intake openings. Avoid overloading the engine by raising the cutting height or slowing down the front mower. If the engine oil filter is clogged, ask your dealer to replace it.
  • E
    Erik ThomasAug 23, 2025
    What to do if Iseki Lawn Mower starter motor works but engine does not start?
    • A
      Amanda WiseAug 23, 2025
      If the starter motor works but the engine doesn't start, first, ensure the cock of the fuel strainer is open and that there is enough fuel. If there's water trapped in the fuel, drain it from the fuel strainer. For air trapped in the fuel, bleed the injection pump. Clean any clogged fuel hoses or wash/replace a clogged fuel strainer. If the cranking speed is slow, charge the battery. Preheat for the specified time if there's insufficient pre-heating. Make sure the throttle lever is in the high-speed position and that the engine hood is closed securely. If the engine oil viscosity is too high, replace it with a lower viscosity one. Also, clean the air-cleaner element.
  • B
    Brenda JonesAug 26, 2025
    Why Iseki Lawn Mower engine output is insufficient?
    • J
      Juan SandovalAug 26, 2025
      If your Iseki Lawn Mower's engine output is insufficient, ensure that there is enough fuel and that the air cleaner is not clogged; clean the element if needed. Avoid overloading the engine by raising the cutting height or slowing down the front mower. Verify that you are using the proper diesel fuel and cool down the engine if it is overheated. Make sure the throttle lever is securely in the high-speed position. For insufficient compression, improper valve clearances, defective injection pump or nozzles, or incorrect injection timing, consult your dealer.
  • L
    Lisa PerezAug 28, 2025
    What to do if Iseki Lawn Mower engine runs at irregular speeds?
    • C
      Charles GilmoreAug 28, 2025
      If your Iseki Lawn Mower engine runs at irregular speeds or stalls soon, it might be due to air trapped in the fuel system. Locate the cause of the air-trapping and bleed the system. Ensure proper earthing by polishing earthing points and reconnecting them. Clean or replace a clogged fuel strainer. Tighten any leaking fuel system joints or replace damaged hoses. If the injection pump is defective, consult your dealer.
  • W
    william61Aug 30, 2025
    How to reduce fuel consumption in Iseki SF370 Lawn Mower?
    • E
      Ethan WilsonAug 30, 2025
      To reduce fuel consumption in your Iseki Lawn Mower, ensure you are using the proper fuel. Clean the air cleaner and the inside of the air-intake hose if the air-intake line is clogged. Avoid overloading the engine by raising the cutting height or slowing down the front mower. Replace any damaged fuel parts with new ones and tighten joints securely. For incorrect valve clearances, consult your dealer.
  • J
    Joseph WhiteSep 1, 2025
    Why is the oil pressure lamp blinking on my Iseki Lawn Mower?
    • K
      Kristin NelsonSep 1, 2025
      If the oil pressure lamp is blinking on your Iseki Lawn Mower, it could be due to several reasons: a low engine oil level, in which case you should add oil to the upper limit; low engine oil viscosity, requiring a replacement with oil of higher viscosity; or a clogged engine oil filter, which your dealer should replace. It could also indicate a defective oil pump or oil pressure switch, both of which require consulting your dealer.
  • K
    Kelly SmithSep 3, 2025
    Why is the charge lamp blinking on my Iseki SF370?
    • A
      anthonymitchellSep 3, 2025
      If the charge lamp is blinking on your Iseki Lawn Mower, there may be defective wiring. Correct any loose, dirty, shorted, or improperly earthed terminals. If the electrolyte level is low, replenish it with distilled water to the upper limit. Also, make sure the fan belt is properly tightened. If the alternator or regulator is defective, consult your dealer.
  • J
    Johnathan Luna DDSSep 5, 2025
    Why is my Iseki Lawn Mower engine knocking?
    • M
      Mark SawyerSep 5, 2025
      Your Iseki Lawn Mower engine may be knocking due to a too low engine oil level; add oil to the upper limit. The engine may be overheated or the coolant temperature may not be rising, in which case you should consult your dealer. Also, a defective injection pump can cause knocking, requiring you to consult your dealer.
  • M
    Marilyn Wagner MDSep 7, 2025
    Why Iseki SF370 Lawn Mower exhaust fumes are white?
    • N
      Nicole GreerSep 7, 2025
      White exhaust fumes from your Iseki Lawn Mower can be caused by a clogged air cleaner, so clean the element. It could also be due to too high engine oil level; drain oil to the upper limit. If the issue persists, there might be insufficient fuel injection, which requires consulting your dealer.

Summary

Chapter 1. For Safe Operation

1. How to Be a Safe Operator

Guidelines for safe operation and operator qualifications.

2. Before Starting the Front Mower

Pre-operation checks and safety precautions before starting the mower.

3. Operation of the Front Mower

Safe operating procedures for the front mower.

4. Operation on a Slope

Specific safety instructions for operating the mower on slopes.

6. Loading Onto or Unloading From a Truck

7. When Filling with Fuel

Safety precautions for refueling the mower.

Chapter 5. Controls and Meters

1. Control Panel

2. Steering Post

3. Floor Pedals and Levers

Chapter 6. Pre-Operational Routine Inspection

1. Inspection Items

List of essential items to inspect before operating the mower.

Chapter 7. Operation

1. Before Starting the Engine

Pre-start checks and cautions before initiating the engine.

2. Starting the Engine

Step-by-step guide for starting the mower's engine safely.

3. Stopping the Engine

Correct procedure for safely stopping the engine.

4. Travelling

5. Cruise Control

6. Stopping

Procedures for safely stopping the front mower.

7. Mowing

Steps and safety advice for performing mowing operations.

Chapter 8. Maintenance

2. Engine Oil Level

19. Engine Oil Replacement

33. Periodical Inspection Table

Chapter 10. Troubleshooting

2. Brake System

Troubleshooting common issues with the brake system.

3. Lift System

Troubleshooting issues related to the mower deck lift system.

1. Engine

Troubleshooting common engine problems and their solutions.

4. Steering System

Troubleshooting common issues with the steering system.

5. HST (Hydrostatic Transmission)

Troubleshooting problems with the hydrostatic transmission.

6. Electrical Accessories

Troubleshooting common electrical system issues.

Iseki SF370 Specifications

General IconGeneral
BrandIseki
ModelSF370
CategoryLawn Mower
LanguageEnglish

Related product manuals